![]() It is held in place by rivets.Â* you will need to drill them out (18 rivets in all) Then remove the screw and plastic rivet screw from the bottom of where the rear taillights were that connect to the rear bumper.Ĥ) remove the side covers inside the trunk and remove the 1 screw on each side that connect the bumperĥ)remove side markers and detach from harnessĦ)remove the 2 screws from the rear wheel wellħ)underneath the rear bumper, remove the 3 plastic clips that secure the bumper to the rear crash beamĨ)remove the bumper (first pull the sides off, then pull from the rear)Â* don t forget to disconnect the harness for the license plate lights and rear side lights.ĩ)we can not use the foam padding anymore, but we need to use the stock bumper retainer. Remove the 2 screws on the inside side, then pull out and away, then disconnect harness Then pull up on each side of the the trunk latch to remove the plastic fascia.Ģ) remove screws from inside the trunk to rear bumper (should be 4) You have to remove the plastic fasteners by pulling outward. ******* PLEASE ALLOW A LEAD TIME OF 2-4 WEEKS FOR PRODUCTION AND SHIPPING DEPENDING ON DEMAND.Here is my technique for removing the rear bumper and installing the evo9 rear bumper.ĭo this at your own risk.Â* of course, a body shop would be a better alternative.ġ)open trunk and remove the rear trunk plastic fascia. ****** Ships bare for painting or powder coating prior to installation ***** Bumper is not compatible with Double Throw Down (EVO-1008) **** Bumper is not compatible with cross member mounted rear hitches *** Requires removal of the factory rear cross member Laser cut, CNC press brake formed & fully fixture welded.Provides clearance, body coverage and confidence needed to take on steeper obstacles without concern.Round holes precut to appropriate size to fit 2 ½” grommet LED lights. It features 2 D-ring shackle tabs (for 7/8” or smaller shackles) that are ¾” Steel and are tapered for clearance. ![]() ![]() For strength, the bumper is made from laser cut 3/16” steel, CNC press brake formed and fully fixture welded. This high and tight rear bumper requires no welding and is bolt-on. To maintain frame rigidity, included is a bolt-in replacement frame cross member which aids in keeping the frame strong and true. The bumper contours the bodylines of your JK keeping a clean finished look with minimal overhang. This yields an additional 10 degrees of departure angle over factory rear bumpers while still maintaining complete rear body coverage. To achieve these advantages, we trim down the rear frame overhang by 4.25” and up by 2”. The EVO MFG JK/JKU High and Tight (HnT) Rear Bumper gives you the clearance, body coverage and confidence to take on some of the steepest ledges with decreased concern. Just a few extra inches can be all it takes to get hung up, stuck or damaged. When out on the trail and in the rocks, clearance and departure can mean make or break on certain obstacles. Product Description EVO Manufacturing High and Tight Rear Bumper (Wrangler JK 2007-2018)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |